Clover CDR 4170 Manuel d'instructions télécharger pdf (Page 43)

HDD2 ATTACHING POINT

4. Secure the HDD with the supplied screws as below.

5. Connect the power connector and the flat cable to the HDD.

6. Reassemble the cover.

7. Turn the power on and see if the HDD is being recognized.

NOTE

Be sure that the jumper setting is correct. If not, the system will not recognize the

additional HDD (SLAVE).

FIX SCREW

NOTE

Be sure that the power connector and the flat cable are properly connected.

NOTE

After installing the additional HDD, formatting the new HDD should be performed.

See 5.5.2 Hard Drive for more details.

- 38 -

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 66 67

Pas de commentaire

Clover CDR 4170 Manuel d'instructions Page 43